CFSensor XGZP6103A

Manufacturer: CFSensor. Products & Manufacturers

Industrial pressure transmitter. Values below are manufacturer family specifications; ranges and options differ by ordering code.

Technical specifications

Sensing diaphragm	Ceramic
Nominal range	Up to 40 MPa, depending on variant
Output	4–20 mA and variant-specific other options
Housing	Stainless steel

Official technical documentation

Manufacturer technical source / datasheet ↗

Source reviewed: 17 October 2026. Exact SKU specifications, certifications and ordering options must be verified before product selection.

XGZP6103A — industrial pressure loop

The XGZP6103A family has ceramic diaphragm variants and ranges reportedly extending toward 40 MPa, with 4–20 mA available in specific configurations. Those high-pressure figures describe a product portfolio, not a universal operating rating for one transmitter. Verify ordered pressure span, proof/burst margin, wetted materials and process port before using it with a liquid or hydraulic line. Check available loop supply and load resistance so the controller can distinguish low signal, out-of-range and wiring fault.

XGZP6103A — Ceramic-Diaphragm Industrial Pressure Loop — engineering specifications

Original CFSensor model documentation differentiates the family’s hardware choices. Ranges and options below are manufacturer declarations, not guaranteed simultaneous performance of every part number.

Design item	Manufacturer model evidence	Engineering implications
Measurement physics	Ceramic-diaphragm industrial pressure transmitter in stainless steel assembly	Different technology and media interface from dry-gas PCB XGZP6899D.
Range portfolio	Maker listing shows selected 0–1, 1.6, 2.5 … to 40 MPa configurations	An individual 1 MPa sensor does not have 40 MPa measurement range.
Output coding	4–20 mA ordered variants highlighted; OEM advertises additional analog or I²C choices within product family	Check actual electrical connector and part suffix, not an assumed universal signal.
Media	Ceramic membrane and rugged pressure connection intended for industrial process	Check seals, wetted metal grades and medium compatibility; ‘corrosion-resistant’ is not universal.
Overload/water hammer	Maker advertises anti-overload and anti-water-hammer design for suitable configurations	Require numerical proof/overload limit for actual selected model.
Power / loop compliance	Supply voltage and max load not fixed in general catalog table	Electrical design requires variant manual to validate PLC isolation and cable burden.
Environmental approvals	No blanket ATEX/IECEx declaration for this product from catalog entry	IP enclosure rating or stainless body does not imply hazardous-area certification.

Installation and OEM qualification

An industrial pressure transmitter should be selected by absolute/sealed-gauge reference, wetted media, calibrated pressure span and process thread. Convert 4–20 mA to engineering units using that exact span and handle under-range/wire-break as a fault. Do not connect an analog current-loop variant to I²C solely because the product family page advertises both options. Ceramic process diaphragm is not an automatic approval for aggressive acids, hygienic food contact or explosion-protected installation. Verify exact package and power/accuracy document before use.

Manufacturer source: CFSensor original product listings and order-specific technical materials. Use the exact current datasheet, wiring code and medium/pressure qualification during device acceptance.

AirAlign product editorial revision · 25 October 2026. Final SKU, application pressure certification and photo-license checks remain pending.