Prosense P-3012PE LPG Gas Detector
P-3012PE is a Prosense PE-series fixed detector designed for monitoring LPG with catalytic sensing. The official PE family lists this exact model code.
Manufacturer: Prosense
ATEX marking: II 2G Ex db IIC T4–T5 Gb; Zone 1 or 2. Manufacturer-listed certificates: IMQ 19 ATEX 045 X and IECEx IMQ 18.0009X. Check variant/revision-specific scope and valid certificate before hazardous-area installation.
Model Information
| Gas | LPG |
|---|---|
| Technology | Catalytic |
| Nominal range | 0–100% LEL |
| Signal output | 4–20 mA (PE series) |
| Protection | IP65 PE-family enclosure |
Original Technical and Certification Sources
Official model or PE-series catalog entry → · Prosense PE series and model variants →
Operating limits and accessory approvals may differ by specific model and revision. This summary does not constitute an equipment certification.
Ex certificate source: Manufacturer manual including EU Type Examination certificate IMQ 19 ATEX 045 X → · Manufacturer conformity declaration for P/PE/PEK/PES →. Always verify certificate issue and delivered product marking.
P-3012PE LPG standard PE detector
This is the standard Prosense PE LPG catalytic detector, not the P-3012PEK collision/impact line. A combustible LPG mixture needs the manufacturer’s approved calibration and LEL threshold mapping; do not reuse methane or hydrogen response factors based on sensor-family similarity. Confirm local position/ventilation, analog loop wiring and alarm-panel fault handling for the exact delivered code. Because the page cites PE-family Ex db certification, an installer must still verify the actual nameplate, cable gland, temperature and gas-group restrictions against the current manufacturer certificate schedule before treating the individual device as approved.